FLEETWOOD RV Class A Gas 2020 Owner'S Manual Download

Page: 116 / 176

114

Equipment

SECTION SIX

AUTOMATIC LEVELING

• Extend slideout rooms only when the motorhome

is supported by the leveling system . See “Slideout
Operation” in this section .

•  Park on a solid, reasonably level surface .
•  Apply the park brake .
•  Place transmission in park .
•  The engine must be running for the leveling system

to operate properly .

• Press the On/Off button to turn the system on .
• Be sure all people and pets are clear of the

motorhome and surrounding area .

• Press and release the Auto button . The system will

begin automatic leveling .

• Press the On/Off button to turn the system off .
• Shut off the engine .

MANUAL LEVELING

• Extend slideout rooms only when the motorhome

is supported by the leveling system . See “Slideout
Operation” in this section .

•  Park on a solid, reasonably level surface .
•  Apply the park brake .
•  Place transmission in park and shut the engine off .
•  The engine must be running for the leveling system

to operate properly .

• Press the On/Off button on control pad .
• Press the Front jack button until front jack contacts

the ground .

• Push the Rear button until rear jacks contact the

ground .

• The right and left buttons are used to level the

motorhome side to side . Pressing the Left button
will extend the left rear jack . Pressing the Right
button will extend right rear jack .

•  Repeat steps as necessary to obtain level .
•  Turn the control panel off when level is achieved .
•  Shut off the engine .

JACK RETRACT PROCEDURE

Retract the slideout rooms only when the motorhome is
supported by the suspension . See “Slideout Operation”
in this section .
•  Start the engine .
•  Ensure the park brake is set .
•  The transmission is in park .
•  Press the On/Off button turn the system on .
•  Press  the  All  Jacks  retract  button .  The  jacks  will

automatically return to fully retracted position .

• The Jacks Down light will go out when all jacks

have retracted .

• Push the On/Off button to turn system off .

Low Voltage Light:

• If the Low Voltage light is flashing, leveling system

voltage is low . Start the engine .

• If the Low Voltage light is solid, turn the ignition off

then start the engine to reset the system .

NOTE:

The  leveling  system  is  sensitive  to  movement
during  automatic  leveling .  The  system  may
determine an inaccurate state of level if movement
is  not  restricted  during  the  automatic  leveling
cycle .

WARNING:

The  Excess  Slope  feature  is  disabled  in  manual
mode .  Do  not  apply  excess  torsion  twist  when
leveling .  Damage  to  the  motorhome  and  related
components will result .

NOTE:

When manually leveling, level front to rear first .
After the motorhome is level front to rear, level the
motorhome left to right .

NOTE:

The Retract button must be pressed and held if the
system is set to manual mode . With the system
set to Auto mode, momentarily press Retract . The
jacks will fully retract .