29
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U300 INSTRUCTIONS
01
09/02/2016
09/02/2016
EN
[+#$+#"#$+!+
NOTES
Before proceeding with the operations provided below, disconnect the machine from the compressed air supply and disconnect the
tube.
$?#&$#*#*&!&%%?&#*&?#<&$#\**>&+*&&$#<'\>"#%&[>#&$!"&&%[#!!&<&
&["*#$!&%"#%[!#&%&#&$?"#%>?$?&<%'#*&<>%?&#&%?#+?#<[}'*$""%[&#*!##`&
and loader.
To perform mechanical alignment, proceed as follows:
1. Undo the socket head screw securing the head to the L-block support and remove the head from the support.
}&%?$>$&%?}'*$""%%%?&&%
3. Slacken the M5 screws on the two magazine locks.
4. Without forcing it, move the L-block support up to the hammer making sure that the two parts come into contact then tighten the socket head
screws.
5. Without forcing it, move the magazine up against the hammer after having loosened the two M5 screws locking the magazine in place.
6. Check that the coupling between the V-nail magazine and hammer is perfect.
7. Tighten the M5 screws which lock the magazine in place.
8. Insert a V-nail in the magazine, move it up against the L-block support to check that the wings of the V-nail are perfectly in line with the guide.
9. Replace the head on the L-block support taking care to ensure it is perfectly resting on it and then lock in place with the relative screw then
connect the compressed air supply to the machine and switch on.
&%#%$&#*&%?!##`&#&<$!!#&<&#*&>%?&!*<&%$?$$$%;"*&%?&#*
The V-nail must run precisely between the L-block support and the head with minimum play and without any resistance.
1
3
5
8
9
4
6
10
7
2
