44
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U300 INSTRUCTIONS
01
09/02/2016
09/02/2016
EN
7.
It the hammer is worn out or chipped,
proceed to replace the whole piston.
The raised ends of the hammer must
have marked edges to ensure correct
insertion of the V-nail.
8.
Grease the hammer piston and the seals well then insert it in the special hole taking
$#&%%"&$?%?*"#* &%&"@<$*%[%\!@&%?}'*$
support, head and V-nail loader.
9.
Note: position the hammer so that
the high part of the piston has the
two raised edges pointing towards
the magazine.
10.
Replace the cylinder and move it well
up against the head.
Secure in place with the 4 screws and
reconnect the air lines.
At the end of the operation check alignment
of the V-nail firing head: magazine and
head:
reconnect the air supply to the machine and
activate the hammer several times to make
sure it moves correctly and that there are no
mechanical hindrances.
&% %? *#< >%? %? &#* #&<
several times to make sure the V-nails are
$$%*\<!%??#<
7
8
10
9
