30
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U400 INSTRUCTIONS
01
02/10/2015
02/10/2015
EN
"^!+?#$+!+#+"$+*==+&
1. To check correct frame positioning at 90°, you can ask
Alfamacchine to provide you with the transparent right-angle
set square on which the height is shown by a serigraph line.
Position the fence against the travel stop and acting on the
handle, slide the head along the whole route making sure that
the centre of the head is aligned with the line of the fence.
2. Another method for aligning the fences is obtained using a
reference frame with a very precise cut at 90°, 120° or 135°,
depending on the fence being used.
Position the frame against the fence, act on the handle and slide
the head along the whole route making sure that the centre of
the head is aligned with the line of the frame.
Repeat the operation with the other fence.
$$%%?#&*%?&$[*&%?;&$>[
#<%%?"%&'\;"*%&%?>?**&%?%?*%%
obtained the required position, then tighten the screws.
4. The mouldings may have an outer edge which slants slightly.
To achieve better contact between these mouldings, the slant
#*&%?$&%#$%<%?<$#&'#<%<
& %? &' # ?>& & #*&< % #$?@ %?
correct contact edge gradient.
2
3
4
1
