35
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U400 INSTRUCTIONS
01
02/10/2015
02/10/2015
EN
"^+$*=<*%'+&
Depending on the operator’s needs, the workbench can be tilted.
$#\%#<%!&%["$<#**>+
1. Slacken the handle (A) located on one of the legs of the stand, under the working bench.
2. Slowly tilt the working bench to the required position.
3. Re-tighten the handle once the required position has been achieved.
`#$#+&+(!#"^!+
?!#$?&%%<>%?#$##'#*#&$&\%!
?&>&>%?%?!#$?&%*%<[%?"%?'#*#&$&\%!!%'#<%<'\#$%&&%?"*#%
located under the machine.
?!#%"'*%#$*%#%!@!&%%?&#*&&%'\%?"#%&%??#&<*[>?$?<%%?$%#@%\
caused by the tilt would be much heavier to move.
To calibrate the balancing system, proceed as follows:
1. Tilt the machine to the required gradient.
2. Lift the knob (A) on the pressure regulator and turn it clockwise to increase the pressure or anti-clockwise to decrease it. The pressure
*#%#$%&%?'#*#&$&$\*&<$&&$%<%%?&#*&&%$##
3. Move the handle along the stroke and check correct balancing.
$#*'#%&$$%[%?&#*&&%!%!#&&%?"%&&>?$?%??#&<**%%<"[&$#%?"[%
goes up, decrease the pressure..
A
A
B
A
