36
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U400 INSTRUCTIONS
01
02/10/2015
02/10/2015
EN
"^+\ #$)**++
?!#$?&j""<>%?#!'*&#*&&%[#!'*<
on a carriage which is controlled manually by means of a handle.
The maximum stroke of the carriage is 200 mm. Various nail
&%&"&%$#&'<&<>%?&%?#&
?"$%?>&#*&%<#*&%?&'%>&
two mouldings.
(B)
Depending on the thickness of the frame, two or more V-Nails
can be inserted in the same point.
As well as moulding clamping, a braking system (AFC) guarantees
"$%'*$&#*%?&#*&&%<&!*%"*&%&
of V-nails in the same position.
SUGGESTIONS FOR MAKING PERFECT JOINS
1) V-nail types
& < % & %?#% %? !#$?& $#& !# %" j#*%\ &
using a wide variety of materials, different V-nails are available
with different degrees of sharpness suitable for use with different
hardness values and characteristics of the materials being handled.
V-Nails can be divided up into the following categories:
V-nail type
!!
H3 3mm
(optional)
H5
5mm
H7 7mm
H10 10mm
H12
12mm
H15 15mm
It is advisable to carry out a check on the material in question for
selecting the most suitable sharpness.
2) Stapling positions
?**>&<*&#<&<%?*"\%%?'%*%&%!j#*%\&+
-
Avoid inserting V-nails close to the moulding edge. The minimum recommended distance from the outer edge is at least 10mm.
?&$#%&#&>%?%& #*["%&%? #*&%?$&%*&%?#!
\>?%&%! #*#$?&[%#<@#'*%&%%?% #*#%!%?%<#&<%?&&
V-Nail 1/4 from the inner edge.
%&%?@%$#*%""#?>&&%?
A
B
L/2
1/3L
1/4L
L
L
