49
TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Document Code
Rev.
Date saved
Date printed
U400 INSTRUCTIONS
01
02/10/2015
02/10/2015
EN
FREQUENCY
At least once every
six months
When necessary
Every 200 service
hours
LUBRICATION
Maintenance technician
Maintenance technician
Hammer piston
METHODS AND RESULTS
Lubricate the hammer piston by following the instructions provided in the heading
ROUTINE MAINTENANCE.
Lubricate the carriage guides located under the working bench.
To gain access and perform lubrication the maintenance technician must:
1.Isolate the machine from external power supplies.
!@%?;<#<>?&&$#\
3. Using a brush, manually spread a layer of lubricant on the upper part of the
sliding guides.
%#&<$%?;<#<
q*$'&#*+?jj#
Automatic lubrication of the pneumatic actuators.
#%?*&%?@%?*%&%
Remove the reservoir indicated by the arrow by unscrewing it in an anti-clockwise
direction.
Top up, if necessary, with CASTROL MAGNA GC 32 oil or equivalent.
Reposition the reservoir in its seat and tighten it clockwise.
<%%?^>*>?$?<"<&#$$*#%&[%?$$%j&$\
1 or 2 drops every 50 nailing cycles.
