Installation
6
Horizontal Brace
Channel
Vertical Track
Assembly
8.
Attaching the Horizontal Brace Channel
Parts Needed:
Frame Parts
Qty.
Hardware
See Pg 2
Tools Needed
Horizontal Brace Channel
(Page 1 - #7)
2
M6 x 20mm Flat Head Screw
K
4mm Hex Key
1.
Locate the two (2) holes at the bottom, right-hand side of
the Vertical Track Assembly as viewed from the back of
the machine
(see Figure on the right)
.
2.
Lay the left end of the Horizontal Brace Channel over the
holes on the Vertical Track Assembly so all the holes line
up.
3.
Position a second box under the right side of the
Horizontal Brace Channel for support.
4.
Insert two (2) M6 Flat Head Screws through the holes from
the front of the machine (this will mean going from
underneath) using your fingers.
5. Tighten
only the bottom Screw using a 4mm Hex Key. You
will be removing the top Screw later.
9.
Attaching the Left Leg to the Horizontal Brace Channel
Parts Needed:
Frame Parts
Qty.
Hardware
See Pg 2
Tools Needed
Left
Leg
Bottom
(Page
1
‐
#3)
2
2
M8
x
50mm
Button
Head
Screw
M8
Lock
Washer
Q
R
5mm
Hex
Key
1. Locate the Left Leg top-mounted to Vertical Track Assembly.
♦
Note: Remember you are looking at the back of the
machine so the Left Leg is on your right.
2. Open the Left Leg by pulling it to the right.
3. Slide the Left Leg Bottom into the Left Leg Top.
4. Position the Leg over the Horizontal Brace Channel
Bracket on the back of the Horizontal Brace Channel.
5. Align the top two (2) open holes on the Left Leg with the
holes on the Horizontal Brace Channel Bracket.
6. Attach the Left Leg Assembly to the Horizontal Brace
Channel Bracket using two (2) M8 Button Head Screws
and two (2) M8 Lock Washers.
7. Tighten with a 5mm Hex Key.
Horizontal Brace
Channel Bracket
