Installation
8
11.
Connecting the Rear Leg (Free-Standing Unit Only)
Parts
Needed:
Frame Parts
Qty.
Hardware
See Pg 2
Tools Needed
Lower Rear Leg
2
2
2
4
2
M10 x 25mm Hex Head Bolt
M10 Sleeve
M8 x 70mm Button Head Screw
M8 Flat Washer
M8 Hex Lock Nut
A
B
S
O
R
5mm Hex Key
13mm Wrench
1.
Insert two (2) M10 Bolts with two (2) Sleeves to
either side of the Rear Leg Mounting Bracket.
2.
Tighten the Bolts with your fingers.
3.
Open the Rear Leg by pulling up on each portion
of the leg.
4.
Slide the bottom portion of the Rear Leg into the
top portion.
5.
Locate the two (2) holes on the side of the center
of the leg.
6.
Install two (2) M8 x 70mm Button Head Screws,
four (4) Flat Washers (one on each side), and two
(2) Hex Lock Nuts from the left side of the
machine.
7.
Tighten the Screws with a 5mm Hex Key and 13mm Wrench
.
12.
Securing the Frame
Parts Needed:
1.
Tighten all four (4) Rear Leg Mounting Bracket Bolts
using a 17mm Wrench.
2.
Tighten all Front/Back Support Brace Bolts. Use a
17mm Wrench for the Rear Leg Bolts, and a 13mm
Wrench and 5mm Hex Key for the Center Leg bolts.
♦
Note: For Free-Standing FSC, skip to Section 14,
“Attaching the Front Center Leg” on page 9.
Tools Needed
17mm Wrench
13mm Wrench
5mm Wrench
Center Leg
Rear Leg
Front / Back
Support Braces
Rear Leg
M10 Bolt
with
Sleeve
