Installation
9
13.
Preparing the FSC for Wall-Mounting (Wall-Mounted Unit Only)
Parts Needed:
Frame Parts
Qty.
Hardware
See Pg 2
Tools Needed
2
2
M10 x 25mm Hex Head Bolt
M10 Sleeve
A
B
Carpenter’s Level
1.
Insert the two (2) M10 Bolts with Sleeves into the top most holes on either side of the
Vertical Track Assembly.
2.
Lift up the assembled FSC, and nest the two (2) Bolts in the grooves on the Rear Leg
Mounting Brace.
CAUTION: To avoid personal injury, two people should lift the assembled FSC.
14.
Attaching the Front Center Leg
Parts Needed:
Frame Parts
Qty.
Hardware
See Pg 2
Tools Needed
Center Adjustable Leg
(Page 1 - #2)
2
4
2
M10 x 50mm Hex Head Bolt
M10 Flat Washer
M10 Hex Lock Nut
C
E
D
(2) 17mm Wrenches
1.
Align the holes at the top of the Center Adjustable Leg with the holes at the bottom, left side
of the Vertical Track Assembly.
2.
Attach the Center Adjustable Leg to the
inside
of the Vertical Track Assembly using the two (2)
M10 x 50mm Hex Bolts, four (4) Flat Washers (one on each side) and two (2) Hex Lock Nuts.
3.
Tighten the Bolts using two (2) 17mm Wrenches. Position one on the Bolt and one on the
Hex Lock Nut and turn in the opposite directions to tighten.
4.
Pick up the FSC, and place it on its feet.
♦
Note: If you notice any rattling, review the previous steps, and tighten any missed bolts.
15.
Adjusting the Front Center Leg
The Center Leg can be adjusted to be longer or shorter by turning the black Foot left or right. The
Foot has a round ball end for ease of adjustment when contacting the floor. It can be locked into
place by tightening the Lock Nut.
