Maintenance, Adjustments,
Troubleshooting and FAQ
27
If the beam falls across your substrate from top left to bottom right, use a 2mm Hex Key to:
1. Tighten the bottom Set Screw and the beam will move to the right. When it is
positioned over the top of the score line, stop tightening.
2. Tighten the back Set Screw and the beam will turn clockwise. When it is positioned
over the score line, stop tightening.
♦
Note: You may need to continue to make slight adjustments.
If the beam falls across your substrate from top right to bottom left, use a 2mm Hex Key to:
1.
Tighten the top Set Screw and the beam will move to the left. When it is positioned
over the top of the score line, stop tightening.
2. Tighten the bottom Set Screw and the beam will turn counterclockwise. When it is
positioned over the score line, stop tightening.
Use the illustration above to help you adjust the beam until it is perfectly in line with the score line.
Front Set Screw
(closest to you) moves
beam counterclockwise
Bottom Set Screw
moves beam right
Beam is diagonal
to score line
Tightening bottom
Set Screw moves
beam right
Tightening back
Set Screw moves
beam clockwise
Tightening top
Set Screw moves
beam left
Tightening front
Set Screw moves
beam counterclockwise
Beam is diagonal
right to left
