Maintenance, Adjustments,
Troubleshooting and FAQ
28
Nylock Bolt on
the end of
the Laser Shaft
42.
Securing the Blade Cutting Laser Position
1.
Place a 2.5mm Hex Key in the brass-tipped Set Screw located on the top, left-hand side of
the Laser Assembly, and a 10mm Wrench on the Hex Nut opposite the Screw.
2.
Tighten the Screw to create the Blade Cutting Laser Position.
43.
Securing the Cutting Wheel Laser Position
1.
Loosen the Handle and move the Laser to the far right on the Laser Shaft.
2.
If the beam is to the right of the Aluminum Composite Wheel cut line:
a. Slowly tighten the Nylock Bolt, located to the far right end of the Laser Shaft,
using a 16mm Wrench.
b. When the beam is aligned with the wheel cut line, you are finished.
3.
If the beam is to the left of the Aluminum Composite Wheel Cut line:
a. Loosen the Nylock Bolt, located to the far-right end of the
Laser Shaft, using a 16mm Wrench.
b. Slide the Laser over to the right.
c. Continue to loosen and slide until the beam
lines up with the cut line.
d. When the beam is aligned with the wheel cut
line, you are finished.
