v
SAFETY FIRST!
Please read through this manual before operating the Fletcher Substrate Cutter (FSC). If
after reviewing these pages you still have questions about using the machine, contact
our Customer Service Department toll-free at 1.800.843.3826 in the United States. Outside
the United States, call ++860.677.7331 or email customerservice@fletcher-terry.com.
¾
It is the employer’s responsibility to enforce compliance with these safety warnings and
procedures by all who use the FSC. Keep this manual available so all employees who
have access to it and have the opportunity to review procedures periodically.
¾
The intended purpose of the FSC is to cut substrates for use in sign-making. It must not
be modified or used for any other application or purpose.
¾
The FSC is for use in cutting aluminum (up to .063" [1.5mm] maximum thickness),
aluminum faced (1/4" [7mm] maximum thickness), PVC (1/2" [13mm] maximum
thickness), corrugated plastic (1/2" [13mm] maximum thickness), polycarbonate (1/4"
[7mm] maximum thickness), and acrylic substrates and glass. Do not attempt to cut
wood with the Fletcher Substrate Cutter.
¾
Use safety glasses. The operator of this machine, and others in the work area, must
wear safety glasses with rigid side shields.
¾
When lifting the Vertical Track Assembly into place,
DO
NOT TRY TO LIFT IT ALONE
,
as the weight of the assembly could cause injury. Make sure someone is available to
help you lift it.
¾
Only use the parts, supplies, and accessories that are recommended by Fletcher-Terry.
¾
Do not over-reach or use the FSC from an awkward or insecure
position. Make sure that
the work area is well lit, free from clutter, and setup in a way that promotes proper
ergonomics.
¾
IF YOU TURN ON THE LASER SIGHT MAKE SURE TO ALWAYS USE PROTECTIVE
LASER GLASSES
(glasses are not included with machine purchase).
DO NOT
ATTEMPT TO OPERATE THE FSC WITHOUT YOUR PROTECTIVE GLASSES
.
