Reference Board BMR 481 P1E+
287 01-ROA 170 014 Rev A 2018-10-16
12 (12)
10
Electronic loads
In order to perform load transient tests on the modules, up to 5 pcs of PuLS loads
can be connected to the output of the board, see position 10 in Fig 1a.
The PuLS loads (ROA 128 5552/1) can be programmed for different transient
loads and waveforms, see the technical specification for further information. They
do not need to be soldered, the board is prepared for the use of sockets so the
loads easily can be mounted.
