MS713
19
Maintenance and care
WARNING!
Before performing any work on the electric
power tool, pull out the mains plug.
Keep tool clean!
Periodically blow out all air passages with
dry, compressed air.
Remove buildup of grime resulting from
working with green or sappy wood.
All plastic parts should be cleaned with
a soft damp cloth.
NEVER use solvents to clean plastic parts.
CAUTION!
Wear safety glasses while using compressed
air.
Failure to Sart
Should your tool fail to start, check to make
sure the prongs on the cord plug are making
good contact in the outlet. Also, check for
blown fuses or open circuit breakers in the
line.
Brush inspection and lubrication
At approximately 200 hours of use, take or
send your tool to your nearest Authorized
FLEX Power Tool Service Agent to be
thoroughly cleaned and inspected. Worn
parts replaced, when necessary.
Relubricated with fresh lubricant, if required
and reassembled with new brushes.
Thereafter, the performance of the tool
should be checked.
Any loss of power before the above
maintenance check may indicate the need
for immediate servicing of your tool. Do not
continue to operate tool under this condition.
If proper operating voltage is present, return
your tool to an Authorized FLEX Power Tool
Service Agent for immediate service.
Repairs
Repairs may be carried out by an authorised
customer service centre only.
Spare parts and accessories
NOTE
Use only original parts supplied by the
manufacturer for replacement purposes.
If non-original parts are used, the guarantee
obligations of the manufacturer will be
deemed null and void.
For other accessories, in particular cutting
accessories, please refer to the
manufacturer’s catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com
Disposal information
WARNING!
Render redundant power tools unusable by
removing the power cord.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EC on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
NOTE
Please ask your dealer about disposal
options!
