PXE 80 10.8-EC
10
Symbols used in this manual
WARNING!
Denotes impending danger. Non-observance
of this warning may result in death or extremely
severe injuries.
CAUTION!
Denotes a possibly dangerous situation. Non-
observance of this warning may result in slight
injury or damage to property.
NOTE
Denotes application tips and important
information.
Symbols on the power tool
V volts
/min
Rotation rate
To reduce the risk of injury, read the
operating instructions!
Disposal information for the old
machine (see page 14)!
For your safety
WARNING!
Before using the power tool, please read and
follow:
these operating instructions,
the “General safety instructions” on the
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
regulations for the prevention of accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool may
be a danger to life and limb of the user or a
third party, or the power tool or other property
may be damaged.
The polisher may be used only
as intended,
in perfect working order.
Faults which impair safety must be repaired
immediately.
Intended use
The polisher is designed
– for commercial use in industry and trade,
– for all types of polishing work with polishing
sponges, lambskins and woolskins, felt
plate, buffing disc,
– for use with polishing tools which are permitted
to run at a speed of at least 5800 r.p.m
Safety instructions for polishing
WARNING!
Read all safety warnings, instructions,
illustrations and specifications provided with
this power tool. Failure to follow all instructions
listed below may result in electric shock, fire
and/or serious injury. Save all warnings and
instructions for future reference.
■ This power tool is intended to function
as a polisher. Read all safety warnings,
instructions, illustrations and specifications
provided with this power tool. Failure to
follow all instructions listed below may result
in electric shock, fire and/or serious injury.
■ Operations such as grinding, sanding,
wire brushing, or cutting-off are not
recommended to be performed with this
power tool. Operations for which the power
tool was not designed may create a hazard
and cause personal injury.
■ Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because the
accessory can be attached to your power
tool, it does not assure safe operation.
■ The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool. Accessories running
faster than their rated speed can break and
fly apart.
■ The outside diameter and the thickness of
your accessory must be within the capacity
rating of your power tool. Incorrectly sized
accessories cannot be adequately guarded
or controlled.
■ Threaded mounting of accessories must
match the grinder spindle thread. For
accessories mounted by flanges, the arbour
hole of the accessory must fit the locating
diameter of the flange. Accessories that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
