www.flexco.com
—8—
e
Changing the Blade
!
WARNING
Keep fingers and hands away from blade cutting edge.
1. Loosen the blade set screws.
2. Carefully remove the blade and backing plate from the blade holder leaving the shims in place.
3. Insert a new blade on top of the previously installed shims. Ensure that the slot in the blade is seated around
the pin on the blade holder. When properly installed, the opposite end of the blade farthest from the belt is
seated and is completely recessed in the blade holder.
4. Replace the backing plate on top of blade ensuring that the slot is seated around the blade holder pin.
5. Replace shims under blade.
6. Tighten blade set screws.
7. Carefully dispose of old blade.
Blade
Backing
Plate
Correct Notch
Blade Holder Pin