Replace the battery
. Unpackage the spare battery. Clip the lead into the appropriate terminal.
Wait.
Once the battery is plugged in, wait at least 30 seconds before powering on the device.
Failure to wait may result in a false, low-battery warning.
Power on the device
. Before closing the device, turn the power on to ensure the device is
functioning as expected. The battery LED will display 4 green bars.
Replace the back panel
. Place the battery pack in the housing. Position the back panel on the
body so the edges are flush. Tighten the back panel screws and cover the screw heads with the
rubber covers.
Replace the device
. Place the device back on the cleaner.
Inspect the application
. Adjust cleaner tension and inspect the application as needed. Connect
to the device via Bluetooth® wireless communication and make a note in the mobile application
that an inspection was made. If the entire device was replaced, then the new cleaner profile
information entered will act as a cleaner inspection.
6.3 Remove a Device