7
3.2 Cleaner Location Adjustments
Section 3 – Pre-Installation Checks and Options
In certain applications it is necessary to modify the location of the primary cleaner pole due to permanent
obstacles that obstruct the desired location. Relocating the pole location can be done easily and does not hinder the
performance of the cleaner as long as the “C” dimension is maintained.
NOTE: In the following example we will be lowering the pole location in the “Y” direction, but the same method
could also be applied in the “X” direction.
Conveyor situation:
Pulley Diameter: 900mm
X = 450mm
Y = 359mm
C = 575mm
1. Determine the given location dimensions and define the change needed. After laying out the given X & Y
dimensions, determine the distance of the modification required for adequate clearance of the pole and tensioning
system. (In the example we decide to lower the pole 50mm to clear the support structure).
2. Write down known dimensions. We can now determine two of the three required dimension which will allow us
to find the third. We know we cannot alter the “C” dimension, so this will remain the same. Also we are required to
lower the unit in the “Y” dimension 50mm, so we add 50mm to the given “Y” dimension.
X = ? mm
Y =359+50=409mm
C = 575mm
3. Determine final dimension. On a flat vertical surface,
using a level, draw one horizontal line and one vertical
line creating a right triangle (Fig 3a). Measure down from
the intersection the determined “Y” dimension and mark
(Fig 3b). With the tape measure starting at the modified
“Y” mark, swing the tape across the “X” line and mark at
the “C” dimension where it crosses the “X” line (Fig 3c).
Measure from the intersection to the “C” intersection and
this will be your new “X” dimension (Fig. 3d).
X = 403mm
Y = 409mm
C = 575mm
900 mm
Fig. 3a
Fig. 3c
Fig. 3b
Fig. 3d
Y 409 mm
mark
This distance is the new
“X” dimension
403 mm
C 575 mm