8
5.
To adjust air pressure
pull cap
“
1
”
up and turn
clockwise.
After desired air pressure is set,
snap cap
down
into locked position. For optimal results operate
the driver at 85-90 PSI (approximately 6 bar). Do not
exceed 120 PSI (8 bar).
6.
To adjust oil flow
turn cap
“
2
”
clockwise, until tight
,
then
turn cap counterclockwise 1 turn
for proper
adjustment.
1
2
3.
Connect your air compressor to the Parker
No. H2E 3/8” Male Nipple on the regulator kit.
Use compressed air directly from an air compressor.
WARNING: Do not use any bottled gasses,
including oxygen, to operate this tool.
An explosion can occur.
4.
Continue connecting your pneumatic fittings as
shown.
1
2
3
4
5
1
Parker No. H2E 3/8” Male Nipple
2
Parker No. 24 Quick Coupler, Male
3
Parker No. H5EP Nipple 3/8” Push-Lok Hose
4
Parker No. 24-5BP Coupler 3/8” Push-Lok Hose
5
Parker No. H2E 3/8” Male Nipple
Summary of Contents for PSRD-1
Page 15: ...15...
