Match the keypad to the receiver :
A memory can be stored in CHl (press the Sl
button 1 time) or in CH2 (press the Sl button 2
times) After pressing the Sl button the LED will
light on and now the receiver is in learning mode.
While the LED is still on enter your personal code
on your keypad (or if you want to program a
remote control press the button on the remote).
The LED will now turn off and flash. Now you can
use the keypad/remote control. The receiver can
store up to 30 different codes.
For further installation details we refer to the
installation manual included in our products.
Installation Receiver :
Connect the
receiver to the device you
want to operate with your keypad (remote
control). See
schematic drawing for the
correct wiring)
ANT (External Antenna)
GND
CH2
CH1
V+ (+12/24V)
-
v
-
(GND)
Q
uick install manual
Before placing the receiver and keypad in their final position please make sure you
program your personal code first and match your code with the receiver.
Keypad:
Program your personal code:
Press: Enter
Press: 999999
Press: Enter
Press: 2
Press: Enter
Press: a number from 1-9 (the number you choose must
be the first number of your personal code)
Press: Enter
Press: your personal code existing of 3 - 6 digits starting
with the number you choose in the previous step.
Press: Enter
Press: your personal code again.
Press: Enter
(reset: disconnect the battery; press and hold the clear button while reconnecting the battery)
