FlexiForce CE-FLH, User Manual

manual

FF-MANUAL CE-LHR /6                             WWW.FLEXIFORCE.COM 

GB 

Vertical track set      

This is made up of a left-hand and right-hand assembled vertical angles (9K) with track and side seal. 

Horizontal track set 

The horizontal track set consists of a left-hand and right-hand section with a double bend, straight tracks and a 
reinforcement profile. The bends and the straight guide tracks are fitted to each other by connection plates and a 

side plate. The side plate is fitted with a return pulley system. The side plate is supplied pre-assembled.  

Assembly vertical track set

Slide the side seal onto the corner line and shorten this where necessary. Secure the vertical track set level to the 

pendent.  

Ensure that the side seal cannot be displaced. When necessary deform the rim of the corner line above the side 
seal. 

Assembly horizontal track set

Secure a piece of rope to the ceiling or roof structure. Adjust the horizontal track. Tighten all bolts. 

Other instructions can be found in the general Installation Manual of our industrial hardware sets.  
 

WARNING: IN CASE OF INSTALLING THE HORIZONTAL TRACK SET ON HORIZONTAL LEVEL A 688CR 

CABLE TENSION SET MUST BE INSTALLED TO PREVENT SLACK CABLES. ONLY WHEN THE SHAFT IS 

DIRECTLY ACTIVATED (CHAIN HOIST OR OPERATOR). 

OTHER REMARKS

•

On doors with small heights locks must be installed at height less than 700 mm. Otherwise the lock bar 
will hit the cable. 

•

Shape of bottom rubber most be so that it does not hit the side seal when opening the door. 

•

Length of horizontal track on LHR is standard based on mounting a tension set even if it is not part of the 
delivery. 

•

When ordered “double hardware” the standard top roller construction for single hardware is supplied. 

LIST OF PRODUCTS SPECIAL FOR CE-LHR 

Article code 

Description 

567-554-2GD 

Side plate curve assembly LHR 

567-554-2GD-05/28 

Side plate curve assembly FLH 5º / ../../../28º 

593 

  Top 

roller 

575LHR 

  Roller 

575-304LHR   Roller, 

stainless 

steel 

440LHR   

Cable break device LHR 

9K4500 

  Vertical 

angle 

9K6500 

  Vertical 

angle 

688CR   

Tension set LHR right 

2090L   

Bracket for spring bumper 

632L 

Slide bolt with longer rod 

669S 

  Cylinder 

lock