FlexiForce ISC-NL, Installation & Maintenance

manual

ATTENTION! GENERAL WARNINGS!

To install, use and maintain this door safely, a number of precautions must 

betaken. For the safety of all concerned pay heed to the warnings and 

instructions given be low! If in doubt, contact your supplier.

SPECIAL SAFETY WARNINGS OR REMARKS IN THIS MANUAL ARE 

INDICATED WITH THIS SYMBOL:READ THESE WARNINGS CAREFULLY. 

9

This manual has been written for use by experienced fitters and as such is not suitable for d.i.y. purposes or for
use by trainee fitters.

9

This manual describes the installation of the hardware set components, door sections (panels) and refers to
installation manuals of the electrical operators. Be sure to supplement this manual if needed with instructions 
for any additional components not described in this manual.

9

Before starting, read this manual carefully!

9

Certain components may be sharp or have jagged edges. As such you are advised to wear safety gloves.

9

All the components which have been supplied are designed for use with this specific overhead door.
Replacement or adding additional components may have an adverse effect on the safety of, and the guarantee 
on, the door. Also the CE-approval which has been granted to this door combination will be cancelled when 
components are changed or installation is not done according to this manual! Installer is responsible for this.

9

During tensioning, springs can exert large forces. Work carefully. Use the proper equipment. Ensure that you
are standing in a steady position.

9

Ensure that there is sufficient light during installation. Remove obstacles and dirt. Make sure that there is no
one else present other than the fitters. Other people (children!) may get in the way or endanger themselves 
during the installation.

9

Ensure that the building is constructed strong enough to carry the overhead door construction. It is the
responsibility of the installing company to use fixing materials which are strong enough and equipped to fix the 
overhead door to the building.

9

A power operated overhead door may not be equipped with a pull cord (rope). Be sure that this has been
removed when a manual operated door is being equipped with an E-operator.

9

Environments closed by an electrical operated overhead door with operators which are not disconnectable and
where the door cannot be manual operated must be equipped with a pass door.

9

Cutting of the bottom section is not allowed. The forces on cable break devices and bottom brackets are too
high. Cutting is weakening the construction of the door on this critical point.

This door can only be taken into use, when all instructions are followed and:

9

The installer has checked the combination of hardware, panel and e-operator as being approved and safe. Make
sure to check the max. peak force and the proper functioning of the safety edge system in combination with the 
operator.

9

All documentation has been handed over to the end-user: IIa Declaration of conformity, User Guide,
Maintenance Instructions, Dismantling instructions, Service Log Book and this manual.

9

A CE-identification plate has been placed on the door.

9

User has been given instructions and demonstration of the proper use and functioning of the door.

Manual ISC-NL

www.flexiforce.com