13 Advanced Measuring Functions
FLUXUS ADM 8027, F801, ADM 8127B
UMFLUXUS_F8V4-6-1EN, 2018-10-10
95
13.12.2 Intervention in the Measurement
If a program code is active, the message
PROGRAM CODE ACTIVE
will be displayed for a few seconds when a key is
pressed.
The input of a program code is interrupted by pressing key CLR.
If key BRK is pressed:
If a command is selected:
13.12.3 Deactivation of the Program Code
To stop an ongoing measurement, the complete program code has to be entered (= break
code).
Enter the program code with the keys
and
. Press ENTER.
If the entered program code is not valid, an error message will be displayed for a few sec-
onds.
If the entered program code is valid, the measurement will be stopped.
To execute a command, it is sufficient to enter the first three digits of the program code (=
access code).
Enter the first three digits of the program code with the keys
and
. Press ENTER.
At first,
000000
is displayed. If the program code starts with
000
, ENTER can be pressed
immediately.
Select
Special Funct.\Program code
.
The program code is deleted by entering "
------
". Press ENTER.
If the character "
-
" is entered less than six times, this character sequence will be used as
the new program code.
INPUT BREAK_CODE
CODE:
000000
INPUT BREAK_CODE
INVALID CODE !
INP. ACCESS CODE
CODE:
000000
Program code
------
