Step 6
:
Connect the power adapter
Connect the remote control (6), and power adapter (7) to the motor with connecting cable (8).
E
x4
Step 5: Assemble the shelves
As shown on the figure, insert the upper and lower shelves (4 and 5) inclined to the upright
support beam and fix them with bolts (E).
07
08
Operation Guide
Press the UP button or DOWN button to lift or lower the height of the wall shelves.
(1)Press once the UP button, the wall shelves will go up until to the highest point. Press any button
to stop at any position.
(2)Press once the DOWN button, the wall shelves will go down until to the lowest point. Press any
button to stop at any postion.
(3) There are two backup UP and DOWN button on the motor base.
(4) Troubleshooting:
(a) If the indicator light flickers 1 time per second, the buzzer prompts 1 time per second, it is
reminding that the device exceeds the continuous running time. Rest for 18 minutes and use it
again.
(b) If the indicator light flickers 2 times per second, the buzzer prompts 2 times per second, it is a
reminder to reset the device. Press and hold the DOWN button until the shelves move to the
lowest point, then move back and stop. Rest finished.
(c) If the DOWN button doesn't work. Please check the cable connection and cut off the power for
at least 10 seconds. Then reset the device as instructed in (b).
(5) Optional function: if a garage has 2 or more flexispot motorized wall shelves, please pair the
wall shelves with the remote controller following the steps:
(a) Simultaneously press and hold the UP and DOWN button on the motor base to enter the pairing
mode, and the indicator light will flicker. (Press any key to exit the pairing mode);
(b) Keep the remote control aligned to the panel of the motor base and simultaneously press and
hold the UP and DOWN button of the remote until the indicator light stop flickering. The remote can
only control one device at one time.
(c) If the remote doesn't work after changing the battery, pair the device as instructed in (a) and (b).
DOWN button
UP button
4
5
1
E
Connecting Cable
6
7
8
