Flexit 115996, Manual

22

R O O M I E   W I F I

5HVHWȴOWHUWLPHU

•  Select the tab 

Filter

.

•  Press the button 

5HVHWȴOWHUWLPHU

 to reset 

WKHȴOWHUWLPHU$IWHUUHSODFHPHQWRIWKHȴOWHUVWKH

operating hours are displayed above the button (2). 

Emergency shutdown of the unit 

Emergency shutdown of the unit appears if the fan shut-

down lasts above 5 seconds. 

In case of emergency shutdown of any 

Roomie One WiFi

unit in a chain all the 

Roomie One WiFi

 units stop. The 

Roomie Dual WiFi

 units continue to operate. 

In case of emergency shutdown of any 

Roomie Dual 

WiFi 

unit all the other units in the chain continue to 

operate. 

1

2
3

$ODUPLVFRQȴUPHGE\DUHVSHFWLYHDODUPLQGLFDWLRQIRU

all the ventilation units in the network, see page 134. 

To reset the alarm indication troubleshoot the fan shut-

down and restart the unit using the button on the indoor 

unit or the remote control. 

If the alarm indication is still active, please refer to the 

Seller. 

&XWR΍SRZHUVXSSO\WRDGHIHFWLYHXQLWWRHQDEOH

operation of the other units in the network. 

•  Humidity control scenario (for Roomie Dual WiFi):

setting reaction of the ventilation unit for activation of any 

sensor or the built-in humidity sensor. When choosing 

exhaust mode both fans extracts air. 

• 

7XUQR΍GHOD\WLPHU

 setting reset time to a previous 

operation mode for the ventilation unit after activation of 

any connected sensors or the built-in humidity sensor. 

•  Night mode timer: 

setting reset time to a previous 

operation mode after activation of the night mode, 

factory setting 8 hours. 

•  Party mode timer: 

setting changeover time for high-

speed mode after activation of the Party mode, factory 

setting 4 hours. 

• Humidity sensor:

 activation of the humidity sensor. When 

the indoor humidity exceeds the set point (12), the unit 

changes to the high speed. When the indoor humidity 

GURSVGRZQEHORZWKHVHWSRLQWWKHWXUQR΍WLPHUVVWDUWV

countdown and then the unit changes to the previous 

speed. 

• Relay sensor: 

activation of the external relay sensor. 

When the no-contact of the external relay sensor is 

closed, the unit changes to the high speed exhaust mode. 

:KHQWKHQRFRQWDFWLVRSHQWKHWXUQR΍WLPHUVVWDUWV

countdown and then the unit changes to the previous 

speed. 

• 0-10V sensor:

 activation of the external analogue sensor 

0-10V. When a 0-10V control signal value exceed the 

set point (13), the ventilation unit changes to the high 

speed exhaust mode. As the control signal value falls 

GRZQEHORZWKHVHWSRLQWWKHWXUQR΍WLPHUVWDUWVLWV

countdown and upon its elapsing the unit reverts to 

operation with the previous speed. 

• Apply: 

application of all the set parameters in the tab.