Page 5
© 2019 FlexRadio
Connecting the Charging Cable
Pull back the tape securing the Display micro USB cable (red arrow on the image above) and carefully
remove the cable from the PCB board.
Connect the Display micro USB (male) cable to the USB micro (female) / USB A charging cable to as shown
below (red arrow on the image below).
In the Charging cable, connect the USB A (male) connector to the low amperage USB charger. The charger
can be powered by a laptop’s USB port or a Smartphone battery charger that accepts a USB A cable. Allow
the Internal Display battery to charge for at least one (1) hour. Do not use a high amperage tablet
charger as the display requires an initial “slow charge” for proper battery re-charging.
