background image

11

12

Operat ing, Service and Warranty Manual

Flexzilla® Pro Piston Air Compressors with Silencer™, Electric Operated

Warranty shall not apply and WEEMS GLOBAL shall not be responsible nor liable for:

• Rou�ne service such as oil changes, filter replacements, gasket �ghtening to correct oil seepage or drive belt 

   �ghtening and valve cleaning and are not covered under warranty

• Consequen�al damages such as but not limited to cost of loss of business, product damage, or down �me

• Acts of nature, over abuse, malicious destruc�on, improper maintenance, undersized equipment

• In the case the product has been discon�nued at any point the *Limited life�me warranty will last five years past the

   discon�nue date. WEEMS GLOBAL has discre�on to subs�tute parts with current model for the five-year dura�on

• Devia�on from opera�ng instruc�ons or specifica�ons

• Labor charges for repairs or maintenance made by person(s) other than an authorized, approved service technician or 

   any labor a�er the 1-year Standard Warranty expires

• Normal wear and tear parts included but not limited to valves (intake/suc�on, check, blowdown, thermo, pop off, 

   unloader), and ball valves. Belts, sha� seals, load/unloader solenoids, sensors (temperature or pressure), electrical 

   contractors and relays, and any parts with a rou�ne maintenance schedule

Warranty shall be voided under the following condi�ons: 

Exposing electrical components to rain or water, or installing the 

unit in a hos�le environment such as acid vapors or any caus�c or abrasive ma�er that may be ingested into the pump, or 

installing the unit in an enclosed area where lack of cooling ven�la�on is present, such as in boiler or equipment rooms 

where the ambient air exceeds 100F.

Further exclusions include failure to fully and completely follow the guidelines set forth in the manual. Of specific note is 

environments where fine dust is common, such as granite, marble or concrete plants, the compressor MUST be installed 

in a separate area with its own dedicated ven�la�on. 

FAILURE TO PROVIDE THIS DUST FREE OPERATING AREA VOIDS THE 

WARRANTY.

Parts used for warranty purposes must be supplied by Eaton Compressor. Warranty work should be performed by an Eaton 

Compressor approved Technician. If any maintenance (other than rou�ne maintenance) is performed by a non-approved 

Technician, wri�en pre-approval must be obtained from Eaton Compressor, to prevent voiding this warranty. Failure to fully 

comply with this warranty and fully comply with the manual instruc�ons will void this warranty.

Tech Support: 877.283.7614

The oil purchase and maintenance program are effec�ve as of Jan. 2020

FLEXZILLA, The Flexzilla Stylized X and the color CHARTREUSE as applied to the body of the air compressor are all registered trademarks of Weems Industries, Inc.

Silencer™ Patented

Summary of Contents for FXS07V080V1













Reviews: