Rev:
H
Revision Date:
06/19/2012
Page 5 of 14
MAN – FD70CV-M
Specifications
Display Type
7” TFT Color LCD
Supported Resolutions
640x480 1024x768
Display Brightness
450 cd/ m
2
Contrast Ratio
500:1
Dimensions
6.80”(W) x 4.75”(H) x 1.20”(D)
LCD Dimension
6.00”(W) x 3.60”(H)
Weight
1 lb 5 oz
Viewing Angle
140 120
Power
12VDC @ .6 Amps
28VDC @ .3 Amps
Operating Temperature
0-50° C (32-122° F)
PC Video Input
VGA (Analog RGB 15 pin D-sub)
Standard Video Input
2 Composite Video
Video Type Supported
NTSC, PAL
Screen Control
On-Screen Display Menu
Remote Control
IR, included
Materials
Aluminum
DO-160 Testing
Section 21, Category B
Installation Instructions
All cabin entertainment equipment, such as the FD70CV-M, should be installed on a non-
essential bus and have a dedicated circuit breaker. It is a requirement that a switch be
installed in the cockpit so that the pilot can de-energize the entertainment system should it
become necessary.
The order in which you proceed is up to the installation center. We suggest that you first
look at the mounting plate prior to installing the LCD to make sure you have the proper
room and conditions in the aircraft to mount the display to the wall or bulkhead. Once it has
been determined that you have sufficient room and mounting locations for the FD70CV-M,
then it would be appropriate to start mounting the base to the frame. The unit can be
mounted to the bulkhead with fasteners which are located on the rear cover, or installer can
use “L” brackets and attach to the sides (2 located on each side of the display), from back
or sides using the 8-32 fastener. Length of the screw
must not exceed
.250” to the inside
of the screw. Screw length is dependent upon thickness of the “L” brackets.
NOTE:
Care
should be taken to ensure the unit is not installed in an area with poor ventilation, or
in an area with excessive heat.
