MWI-05-001 – Rev. B
2
2.
Safety Measures
You must know whether your lighting system is powered by AC or DC before installing the
fixture. AC models work on a range of 100 to 277VAC and DC models operate from 12 to
48VDC. The lights are designed to be installed in a parallel circuit, which maintains a constant
voltage and brightness for all lights.
Ensure power is off before installing or servicing lighting fixtures!
Follow the local electrical code!
Make sure the equipment is rated and approved for the environment in which you are intending
to use it. Do not operate this equipment in humid, flammable, or explosive environments unless
it has been rated for safe operation in these environments.
Use only electrical wire of sufficient gauge and insulation to handle the rated current and voltage
demand.
Route electrical wiring along a protected path. Make sure they will not be damaged by moving
equipment.
Protect components from harsh environment conditions.
Protect equipment with safety devices as specified by applicable safety regulations.
Before starting this equipment, check all safety interlocks, fire –detection systems, and protective
devices such as panels and covers. Make sure all devices are fully functional. Do not operate the
system if these devices are not working properly.
Never operate equipment with a known malfunction.
Do not attempt to operate or service electrical equipment if standing water is present.
Do not touch exposed electrical connections on equipment while the power is ON!
Wiring and electrical design should be authorized by an electrical contractor.
To provide maximum protection from surges, ensure that the system ground is tested and
provides less than 25 ohms to ground resistance.
Summary of Contents for L810LED
Page 2: ...MWI 05 001 Rev B ...
