MWI-05-001 – Rev. B
3
3.
Installation
The FAA has published guide specifications for the installation and maintenance of obstruction
lighting products. FAA advisory circulars may be obtained by direct internet access or by
contacting FAA.
Direct Internet Access:
https://www.faa.gov/documentLibrary/media/Advisory_Circular/AC_70_7460-
1L_with_chg_1.pdf
FAA AC 70/7460-1L
The installation of a new complete L810 LED light is similar to that of an incandescent light
source assembly.
1.
Verify that all supply power is off
2.
Use the below wiring diagram and ensure your incoming power is matching the voltage
the light was built for.
3.
Connect the wires from the fixture to the wires from the power source
4.
Make sure the connection is done in a protected, waterproof enclosure.
3.1
Wiring Diagram
Summary of Contents for L810LED
Page 2: ...MWI 05 001 Rev B ...
