MWI-05-001 – Rev. B
5
3.2.2 Mounting Options:
A.
Low Surface Mount
1.
Mount box to surface
2.
Install fittings or conduit using sealing compound on threads.
3.
Pull supply wires into box.
4.
Thread the light into the cover and run the wires through the top hole and through the gasket.
See picture below. Connect/Splice them to the incoming power cables.
5.
Attach system ground wire under head of green screw in box.
6.
Center cover gasket evenly. Locate pre-perforated holes in the gasket and install the gasket
so they align with the mounting holes in the box. Install cover with the two screws provided.
7.
Use caulking around cover.
8.
Cover the conduits that are not used with the plugs provided.
Summary of Contents for L810LED
Page 2: ...MWI 05 001 Rev B ...
