19
13)
Now we can hang this assembly within the Roll Frame. See below. Use the same brass
bushing and large bolt that were used on the Pivot Bearings. Ensure the brass washer is
placed between seat hanger bushing and Roll Frame bushing. This washer is nesecary to
prevent wear and to ensure smooth fluid motion. One washer is required for each side.
Once the seat assembly is hung within the roll frame the large bolts can be tightened until
they stop turning. Ensure the same free motion is felt at these two pivots like was felt on
the Pivot Bearings earlier. If there is any friction disassemble and clean and re-assemble.
Summary of Contents for Dreamflyer FMS df X-2
