24
18)
The final steps are listed here. Attach the throttle and Throttle Mount to the Roll Frame.
See below. Customer supplied monitor can now be attached to the assembly using the
enclosed monitor mount screws. These screws are slightly longer than the stock screws
that came with your monitor. Carefully route all cables so as not to interfere with full
motion of the flight simulator. Also ensure that the cables will not rub or be pinched
causing damage to the cables. Joystick control bands may now be attached under the seat
between the four eyehooks ant the joystick post.
Summary of Contents for Dreamflyer FMS df X-2
