Explanation
Label
Yes
or
No
If
Yes
is selected the active video signal is
swapped between the two video outputs on the
pan/tilt head when the operator toggles between
IR and TV.
If two monitors are used (one for IR and one for
TV) this means that the images move between the
monitors, instead of only moving the indicator for
active channel between the monitors.
SEE: See section 7.2.2.7 – Active channel indicator
on page 13.
IR/TV video swap
Yes
or
No
NOTE: Selecting
Yes
resets all parameters to
factory settings.
Default settings
8.2.4.6
System info
10056203;a1
Figure 8.10
System information
dialog box
The
System information
dialog box contains information about the system, such as:
Explanation
Label
NTSC
or
PAL
Video mode
Hours and minutes
Runtime
Configuration number
System check ID
Hardware and firmware information is also available.
Publ. No. 1 557 544 Rev. a121 – ENGLISH (EN) – October 6, 2005
27
8.2 – On-screen menus
