22.3.6
Enabling or disabling GPS
General
The camera has an internal GPS module that stores GPS data in a tag inside the JPG
image. In FLIR Reporter you can then read out the GPS data and display the position
where the image was taken on, e.g. Google
®
Maps.
Procedure
Follow this procedure to enable or disable GPS:
To go to the mode selector, push the
button to the right of the joystick.
1
In the mode selector, select
Setup
and push the joystick.
2
In the toolbox, select
GPS
.
3
To enable or disable GPS, use the joystick. Push the joystick to confirm
each choice.
4
To confirm and leave the dialog box, push the
button.
5
NOTE
GPS data are displayed at the bottom of the toolbox, or, optionally, in the status
bar in the infrared image.
■
■
The GPS module cannot retrieve GPS data when the camera is used inside
buildings. Further, displaying GPS data is dependent on many factors, such as
terrain, high buildings around the camera, and the number of detected satellites.
Related topics
For locations of camera buttons, see section 9 – Camera parts on page 21.
22
Publ. No. 1558550 Rev. a557 – ENGLISH (EN) – October 7, 2011
141
22 – Changing settings
Summary of Contents for B6 series
