Setup — Screening station (Auto and Button mode)
Figure 10.1
Screening position
floor sticker
Figure 10.2
Backdrop
10.2.4
Materials and tools
The following materials and tools can be useful:
• Measuring tape or yardstick.
• Screwdriver.
• Masking tape.
• Cable ties.
• Extension cords.
• Cable covers (to prevent people from stumbling over the cables).
10.3
Step-by-step setup instructions
Before starting the setup, please read the instructions for the entire setup procedure.
Make sure you have all the needed equipment and material, see section 10.2
.
Note
The setup as described in this section is adapted for persons with an average
height of 170 cm (5.6 ft.). With this setup, the system will screen persons with a height of
150-195 cm (4.9–6.4 ft.). To adapt the setup for other average heights, see section 10.4
.
10.3.1
Main steps
The setup procedure includes the following main steps:
1. Plan and prepare the screening station.
2. Prepare the camera.
3. Prepare the button (Button mode).
4. Place the camera and display.
5. Define the screening position.
6. Adjust the angle of the camera.
7. Test the setup.
8. Place the queueing system and supporting materials.
9. Clearly mark the screening position.
10. Mark the positions of all equipment.
10.3.2
Plan and prepare the screening station
Before you set up the screening station, you need to do some planning. Where will you
conduct the screening? How should the visitors flow into the screening station and out?
Who will be the operator? What should happen in case of a screening alarm?
• For factors to consider related to the area around the screening station, see section
Screening station considerations
• For factors to consider related to the policies of your company, see section 11.4
.
#T810583; r. AA/75420/75423; en-US
41
