427-0101-01-12 Revision 100
September 2020
26
This document does not contain any export-controlled information.
Configuration
•
Gateway
When the IP address mode is set to DHCP, if a DHCP server is not available on the network, the
radar's IP address defaults to 192.168.0.250. For information about defining the radar's IP address
using the DNA tool, see
Configuring the Radar for Networking
.
Caution!
When the IP address mode is DHCP, you can set the DNS Mode to DHCP or Static. When the IP
address mode is Static, the DNS Mode is also Static.
When the DNS Mode is set to Static, specify:
•
Name Server 1
—The primary domain name server that translates host names into IP addresses
•
Name Server 2
—A secondary domain name server that backs up the primary DNS
You can also specify the:
•
MTU
—Maximum transmission unit, the largest amount of data that can be transferred in one
physical frame on the network. For Ethernet, the MTU is 1500 bytes (the default setting). For
PPPoE, the MTU is 1492. Valid values are 1000-1500.
4.2
Date & Time Page
Use the Date & Time page to configure the date and time settings.
The radar can obtain the date, time, and time zone from an NTP server, or you can manually specify
that information.
When set to Manual mode, you can copy the local PC’s time or specify the hour, minute, second, or
date.
After changing the radar's IP address, the PC you are using to access its web page might no
longer be on the same network and can no longer access the radar's web page. To access its web
page again, change the PC's IP address to be on the same network as the radar.
