427-0033-00-12 Version 110
February 2019
16
This document does not contain any export-controlled information.
Basic Operation and Configuration
network does not have a DHCP server, the camera will default to an IP address of 192.168.0.250.
Configuring the camera for IP communications generally involves the following steps:
Step 1
Connect the Ethernet port of the camera to the existing IP camera network.
Step 2
Connect a PC or laptop to the same network.
Step 3
From the PC connected to the camera network, use the DNA utility to discover and display
the camera’s current IP address.
Step 4
Right-click on the camera, select
IP
Setup
to change the IP address or select
between static IP or DHCP addressing.
Step 5
Double-click the camera in DNA’s
Discovery List
to open the camera’s
web server
Login
page in a web browser
or point your web browser to the
camera’s IP address.
Step 6
Using the web browser, configure the
camera settings, such as camera date/
time, and other parameters, so the
camera is compatible with the existing
network.
2.2.2
Log in to the Camera Web Page
Use a web browser to connect to the camera’s web server using one of three User Names:
user
,
expert
, or
admin
(the default passwords are
user
,
expert
, and
admin
respectively).
Important Note
The
user
login can be used to do the initial bench test of the camera. The
expert
login may be used
to make configuration changes such as setting the IP address and other server settings. The
admin
login has access to all configuration, setup, and maintenance settings.
To prevent unauthorized access, change all of the login passwords (
admin
login required). For
information on how to change the passwords, refer to
.
Online manual
Select IP Setup
Right-click
