427-0033-00-12 Version 110
February 2019
28
This document does not contain any export-controlled information.
Basic Operation and Configuration
After making configuration changes, save the changes (there is a
Save
button at the bottom of each
configuration page). The configuration changes do not take effect immediately. Generally, it is also
necessary to stop and restart the server for the changes to become active. The server has a
configuration that is active and running, and another configuration that is saved (and possibly
different than the running configuration).
The message at the bottom of the page indicates that it
is necessary to restart the server.
It may take up to 20 seconds or more to stop the server, especially when there are multiple video
streams open. Be patient when stopping the server.
When the server is stopped and the page is refreshed, the status will
show Server Stopped and the Start button will be enabled.
Click on the Start button to restart the server, and when the page
refreshes, the status will again show Server Running. The Start button
will be replaced by a Stop button when the startup procedure has
completed.
Security Options
Use the
Security Options
page to restrict access through the camera web server to specific IP
addresses and to set or change passwords. The
admin
login can change or set any password. The
expert
login can only configure the
expert
login password.
As an additional security measure, limit which computers have access to the web browser interface.
Simply add a computer’s IP address and click Add. After all the allowed IP addresses are entered,
select the
Save
button to save the changes.
Note
A VMS Remote to the camera, ONVIF or Nexus CGI, uses the same password as the web interface.
Refer to
.
Add IP
address
