427-0033-00-12 Version 110
February 2019
46
This document does not contain any export-controlled information.
Advanced Configuration
VMS Remote:
The VMS Remote page provides communication interfaces for devices that connect
to the camera. Authentication when enabled uses the same passwords set from the
Server Security
Options
Nexus CGI Interface
After the interface is configured, scroll down and click on the
Save
button to save the configuration.
The changes will not take effect until the server is stopped and started.
ONVIF Interface
The ONVIF (Open Network Video Interface Forum) is an open industry forum for the development of
a global standard for the interface of network video products. Refer to the VMS documentation to
determine what parameter values are needed. By default, the camera is configured with a VMS
Remote interface with ONVIF 2.0 parameters (Profile S).
Several types of third-party Video Management Systems (VMS) are supported by FLIR IP cameras.
Because these systems tend to evolve and change over time, contact the local FLIR representative
or FLIR Technical Support to resolve any difficulties or questions about using this feature.
IOI Interface
Install this interface to hand-off F
-
Series ID detection events to the PTZ Tracker (trk-101-P). In order
to implement a hand-off from the F
-
Series ID camera to a PTZ camera, the F
-
Series ID camera and
trk-101-P are bound together from the web interface of the trk-101-P or from the FLIR Latitude
Network Video Management System. Users can define perimeters and areas for the F
-
Series ID
camera to monitor (refer to
). When a moving object is detected by the
F
-
Series ID, the trk-101-P can control and move a PTZ camera to track and zoom in on the motion.
For ONVIF,
use the settings
in Interface 1
Scroll down
use the settings
For Nexus CGI,
in Interface 0
