3—Operating Your H-Series Camera
H-Series Operator’s Manual
10
November 2009
3–2
Installing the Batteries and SD Card
The batteries must be installed and charged before using your
camera. If an SD card is included with your camera package, you can
also install it at this time.
1. Remove the small SD card
door. No tools are required.
This will help later when
removing the battery cover.
2. If included with your camera
package, install the SD card.
3. Loosen the four captive screws
securing the battery cover.
4. Pry off the battery cover by grasping
the front edge exposed when the SD
card cover was removed.
5. Install the batteries as shown.
6. Snap the SD card door back into
place, ensuring that the rubber lanyard
retracts into the camera.
7. Re-install the battery cover—it only fits one way.
8. Tighten the four screws.
If you have installed rechargable batteries, they must be charged
before using the camera. Regular AA batteries will provide about one
and a half hours of camera use.
Grasp SD card door edges and pull
Battery
cover
+
–
+
–
–
+
–
+
HS_Series_Operators.book Page 10 Thursday, November 5, 2009 12:58 PM