3—Operating Your H-Series Camera
H-Series Operator’s Manual
14
November 2009
3–5
Buttons and Controls
Power Button
Changing between the Off, On, and Standby power states is
controlled by the Power button. The table below describes
how the camera moves between states.
To shut off the camera completely press and hold the Power button
for eight seconds.
After holding the Power button for three
seconds the following message will be
shown in the display and the camera will
enter the Off state if the countdown
finishes.
Release the Power button at any time during this countdown to
terminate Shutdown and resume normal operation.
Note
From
State
To
State
Method
Off
On
Press the Power button for 1 second. (This will put the
camera in power-on bootup for about 90 seconds
before going to On.)
On
Standby Momentarily press the Power button
Standby On
Momentarily press the Power button
On
Off
Press and hold the Power button for 8 seconds
Standby Off
Press and hold the Power button for 8 seconds
If the camera is in the Standby state and the Power button is held
down for eight seconds, the camera will shutdown without warning.
HS_Series_Operators.book Page 14 Thursday, November 5, 2009 12:58 PM
