20
intelliRock® III– Operating Instructions Guide
Starting and Using Loggers
Starting an intelliRock Logger
To setup and start a logger, connect the wires from the logger you wish to start to the terminals
shown in Figure 1.8 at the top of the intelliRock reader. It does not matter which color wire goes
to which color terminal. Figure 4.1 shows the reader connected to a logger.
Figure 4.1: The intelliRock III reader connected to a logger.
When the logger is successfully connected to the reader, the screen may briefly display the
message “Testing” then “Good Link” before displaying the logger setup screen shown in Figure
4.2.
Figure 4.2: intelliRock startup screen for a new logger.
