Explanation
Value
Label
■
Select
Laser
to activate the laser when pulling
the trigger
■
Select
Save
to save the current image when
pulling the trigger
■
Select
Disabled
to disable the trigger
■
Select
One-shot autoadjust
to autoadjust the
camera when pulling the trigger
■
Select
Update ref. temp
to update the reference
temperature when pulling the trigger
If
Update ref. temp.
is selected:
By pulling the trigger for more than 1 second, a
dialog displaying the message
Restart ref temp
at nn.n °C?
will appear.
Do one of the following:
■
Select
OK
to purge the internal camera buffer
and begin a new sampling sequence
■
Select
Cancel
to leave the dialog box
■
Laser
■
Save
■
Disabled
■
One-shot autoadjust
■
Update ref. temp.
Trigger
■
Select
Low
to set the LCD intensity to the lowest
level
■
Select
Medium
to set the LCD intensity to
medium level
■
Select
High
to set the LCD intensity to the
highest level
■
Low
intensity of the
LCD
■
Medium
■
High
LCD intensity
If the camera is switched on but currently not used,
it will automatically be switched off after a specified
time.
Set the time by pressing the navigation pad
left/right.
■
None
■
2 min
■
5 min
■
10 min
Auto power off
If the camera is switched on but currently not used,
the display will automatically be switched off after
a specified time.
Set the time by pressing the navigation pad
left/right.
■
None
■
30 sec.
■
60 sec.
■
2 min.
Display power off
➲
For protective reasons, the LCD will be switched off if the detector temperature
e60 °C (+149 °F) and the camera will be switched off if the detector temper-
ature e68 °C (+154.4 °F)
10
86
Publ. No. 1557882 Rev. a156 – ENGLISH (EN) – February 28, 2006
10 – Camera program
Summary of Contents for ThermaCAM B2
