9.5
Laser LocatIR
The ThermaCAM™ P45 infrared camera features a laser pointer located at the front
of the camera handle. To display the laser dot, press the Laser LocatIR button on left
side of the handle. The laser dot will appear approx. 91 mm/3.6" above the target.
➲
Please note the following:
■
A laser icon appears on the screen when the Laser LocatIR is switched on.
■
Since the distance between the laser beam and the image center will vary by the
target distance, Laser LocatIR should only be used as an aiming aid. Always check
the LCD to make sure the camera captures the desired target.
■
Do not look directly into the laser beam.
■
When not in use, the Laser LocatIR should always be protected by the lens cap.
10376403;a2
Figure 9.8 Wavelength: 635 nm. Max. output power: 1 mW. This product complies with 21 CFR 1040.10
and 1040.11 except for deviations pursuant to Laser Notice No. 50, dated July 26th, 2001
10395103;a3
Figure 9.9 Distance between the laser beam and the image center
9
68
Publ. No. 1557966 Rev. a155 – ENGLISH (EN) – February 6, 2006
9 – Camera overview
Summary of Contents for ThermaCAM P45
