NOTE
Before proceeding to put this device into professional operation ensure that all system, safety,
and programming information is well understood as explained in this user manual.
NOTE
Please update the VS290–00 Videoscope Display’s firmware, as explained in Section 14, be-
fore first use and periodically thereafter, to ensure optimum performance.
8.1
Charge and Install the Battery
As discussed in Section 5,
Battery Charging
, place the batteries in the sup-
plied bay charger. Connect the charging bay to the supplied AC adaptor, and
then connect the AC adaptor to an AC source to begin charging.
Once charged, insert a battery into the VS290–00 and long press the power
button
to power the instrument.
8.2
Power-up Display Configuration
When you power up the VS290–00, the display will show the camera image
for the currently selected Image Mode (Thermal MSX, Thermal, or Digital
camera). The digits and icons that are displayed also depend on the configu-
ration of the camera. See Section 4.5,
Display Description
, for details.
8.3
Programming the Instrument
Before taking measurements you’ll want to configure the instrument to best
match the application at hand. See the following parameter list for the most
commonly used options. Refer to Section 7,
Programming Menus
, for com-
plete instructions on these and other options.
• Image Mode (Thermal MSX, Thermal-only Camera, or Digital Camera).
• Thermal display color palette.
• Measurement Mode (Color spot, Hot spot, Cold spot, or No
Measurements).
• Emissivity.
• User interface Language.
• Temperature units (
℃
/
℉
).
• Auto Power Off (APO) timers for the worklight and the VS290–00.
• Display and worklight brightness.
#NAS100060; r. AB/80750/80750; en-US
29
Summary of Contents for VS290-00
