Safety & Installation Guide
Version: 01.12
Valid from 22.10.2018
FG2P1-4S1P00/1
14
This manual
applies only on Flisom’s eFlex Series modules
5
Operation
According to local regulations it might be necessary to contact authorities before the PV system is
connected to the grid. Also check if this has to be performed by authorized personnel.
6
Inspection and Maintenance
It is recommended to have a visual check on a regular basis (quarterly). Plan check-ups according to
the given environmental and safety conditions and regulations.
Remove dust and dirt (sediments, leaves, pollen, bird droppings, etc.) from the surface.
Do not use aggressive cleaning agents or scrubbing materials for cleaning
Do not use steam blasting for cleaning.
Use soft water to avoid chalk stains
Soft Sponges can be used
Check if connectors and grounding are tight and without corrosion and if the insulation is not
damaged also check for loose mechanical or electrical contacts.
Check if the Junction Box is securely attached and that no deep scratches are penetrating the
frontsheet
7
Disposal
Flisom eFlex series modules must be disposed of in a responsible manner. Please contact your local
supplier or disposal company for further information. For health and safety reasons, Flisom eFlex
Series modules should not be disposed of with household garbage, and must be dealt with in
accordance with local codes and regulations.
8
Disclaimer
Flisom eFlex series modules can change in appearance and electrical parameters because of the
improvements of components or changes of suppliers or minor design modifications. These changes
are typically made without customer notification. Modules with the same classification have the same
functionality and are fully compatible with one another.
Since Flisom has no control of the correct use of the safety and installation guideline, Flisom is not
responsible for injuries, operational errors, damages and expenses caused by incorrect handling,
installation, operation or maintenance.
Flisom is not responsible for licence or patent infringements or other rights of third parties caused by
the usage of the eFlex Series modules. There is no implicit guarantee of licences, patents implicated.
9
Information
Company Address
Flisom AG
Gewerbestrasse 16
8166 Niederhasli
Switzerland
Tel:
+41 (0)44 824 30 00
Fax:
+41 (0)44 824 30 01
Web:
