Flo-Dynamics
®
TSD450 TS™
V. Troubleshooting & Maintenance
Operations Manual
Printed in the U.S.A. for Flo-Dynamics ®
15
IV. TROUBLESHOOTING & MAINTENANCE
4.01
COMMON PROBLEMS / SOLUTIONS
Problem:
“Power Failure” screen displays
Solution 1:
Check battery connection. Make sure there are no loose connections, and the
machine’s battery clips are not reversed. Remove all corrosion from the battery
terminals. Make sure vehicle’s A/C system is turned off.
Solution 2:
The vehicle’s battery is not putting out enough voltage to run the machine.
Connect the machine to a better 12V power source.
Stand-alone shelf batteries will not work.
4.02
MAINTENANCE PROCEDURES
• Replace Canister Filters
(Part#: 940796A)
when machine prompts you to do so:
Use a standard filter band clamp tool to unscrew old filters, and replace them with new filters.
Make sure new filters are on tight.
• Clean Waste Fluid Screen (Located in bottom of recessed hose tray area)
This helps eliminate surface tension caused by debris and contamination from the air.
Using a sharp pick, remove screen. Clean using degreaser and brush, and blow out with air
compressor.
• Periodically Wipe Down Exterior using a soft, damp cloth.
Summary of Contents for TSD450 TS
Page 19: ......
