TTCF-9A
Variable High Flow Heated
Hydraulic Component Flusher
40201409
QUICK START
INSTRUCTIONS
Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874
Page
3
of
5
Press START/PAUSE and check the following:
o
Secure fill cap
o
Secure filter screen
o
Check fluid level
o
Check all connections
o
Set flow rate
o
Set flow direction
Press the START/PAUSE button to start the flush cycle.
At the end of a flush cycle, the flusher will stop and signal
with an audible sound. The display will show “FLUSH
COMPLETE” with before and after flush cycle results.
Press the manual air purge button to clean out the lines.
Remove the top half of the filter housing, note debris on
filter screen, clean the screen, and reassemble the filter
housing.
Note: Always use the manual air purge button prior to
removing the top portion of the screen filter housing to
clean out the cooler system and service hoses.
Note: A flush cycle time can be changed anytime by
pressing the RUN TIME button to select a different flush
cycle time.
Repeat until desired system cleanliness is achieved.
Use the manual air purge button to clean out the cooling
system and service lines with the Reverser Valve in either
flow direction, then place in bypass (middle) position.
Remove the service hoses from the system being cleaned,
and use the “U” adapter to connect the hoses together.
Clean the filter screen and reassemble for the next
cleaning.
Move the Flow Control Valve to a minimal flow position.
Unplug the flusher and disconnect shop air.
